Reel Assembly - Toro Greensmaster eFlex 1021 Service Manual

Reel Assembly

g313076
1. Drive spline
2. Reel nut - LH
3. Flange shoulder bolt
4. LH side plate
5. Nut
6. Mount pin
7. Bushing
Removing the Reel Assembly
DPA Cutting Units: Service and Repairs
8. Pitch arm
9. Flange nut
10. Bolt
11. Cutoff bar
12. Strip seal
13. Crossmember
14. Grass shield
This section provides the procedure for removing and installing the reel assembly
(reel, reel bearing, bearing lock screw, reel nut and seals) from the cutting unit.
Note: Refer to Figure 109
1. Ensure that the cutting-unit-drive lever is in the D
machine on a level surface, release the clutch bail, engage the service and
Figure 109
15. Bolt
16. Flat wire spring
17. Sealed bearing
18. Seal
19. Reel assembly
20. Nut
21. RH side plate
during this procedure.
Page 7–18
22. Reel nut - RH
23. Gasket
24. Counterweight
25. Bolt
position, park the
ISENGAGE
Greensmaster ® eFlex 1021
20248SL Rev C