Removing The Front Cover Assembly; Removing The Side Screens; Lubrication; Greasing The Machine - Toro TX 1300 Operator's Manual

Removing the Front Cover
Assembly
1. Raise the loader arms and secure them with the
cylinder locks.
2. Open the hood.
3. Remove the 4 bolts securing the cover assembly
to the machine.
Figure 65
4. Remove the cover assembly.

Removing the Side Screens

1. Open the hood.
2. Slide the screen out of the front and rear slots.
Figure 66
1. Side screen

Lubrication

Greasing the Machine

Service Interval: Before each use or daily (Grease
Grease Type: General-purpose grease.
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Clean the grease fittings with a rag.
g363210
4. Connect a grease gun to each fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
6. Wipe up any excess grease.
g363164
45
immediately after every washing.)
Figure 67
g359308