Samsung OfficeServ 500 Programming Manual page 433

SIP PARAMETER
No Parameter
0 RE-TRANS T1
1 RE-TRANS T2
2 RE-TRANS T4
3 GEN RING TM
4 INV RING TM
5 GEN NO RESP
6 INV NO RESP
7 REQ RETRY
8 PROVISIONAL
CONDITIONS
NONE
DEFAULT DATA
SEE DESCRIPTION
ACTION
1) Press Transfer button and enter 845.
2) When the cursor is at WLAN, press UP or DOWN
and select WLAN, WBS, or SIP.
3) Press Soft button and move to the SYSTEM ID.
When the cursor is below SYSTEM ID,
press UP or DOWN key and select
the setting menu for WLAN.
© SAMSUNG Electronics Co., Ltd.
When using an unreliable transmission protocol such as UDP,
retransmission is required when no reply is received. RE-TRANS.
T1 TIME is the initial retransmission interval defined in RFC2543.
Maximum retransmission interval defined in RFC 2543
RFC 2543 defines this parameter for various purposes.
For example, this parameter can be used as the time waited by User
Agent Server(USA) after receiving ACK message in an unreliable
transmission protocol.
When using an unreliable transmission protocol, the server cannot be
sure if the client has received the last reply.
Thus, the server must retransmit the reply for as long as this time until
it receives the requested retransmission. For example, this parameter
can be used as the waiting time after sending 200 OK for INFO.
When using an unreliable transmission protocol, the client cannot
verify if the server has received the ACK returned to the server for the
INVITE Final Response. The client waits for as long as this time after
sending the ACK for the Final Response.
Waiting time until canceling SIP related Request.
Waiting time until canceling SIP INVITE Request.
Waiting time until receiving final response for SIP related Request.
On receiving Provision Response, the User Agent must wait for as
long as this time until Timeout.
OfficeServ 500 Programming Guide
Description
DISPLAY
WLAN: SYSTEM ID
WBS24
WLAN: SYSTEM ID
WBS24
WLAN: SYSTEM ID
WBS24
2-391