Card Pre-Install - Samsung OfficeServ 500 Programming Manual

CHAPTER 2. Ошибка! Стиль не определен.

[806] CARD PRE-INSTALL

Allows the preprogramming of a card slot for a specific board type. A board inserted into a
system will not be recognized by the system until it is ENABLED using this MMC. Cards
installed using MMC 806 will NOT be assigned in the system numbering plan. You must
then use MMC 724 to assign the desired directory numbers to extensions, trunks, AA, ports
or miscellaneous functions. This MMC also shows which PSU is powering the card
selected.
POWER STATUS
N: 48V Power does not used.
st
A: 1 Power is used.(1
nd
B: 2 Power is used.(2
st
1: 1 Power is used.(1
nd
2: 2 Power is used.(2
[xx]: The maximum port count which 48 V power is supplied.
When a card is removed and a different type card is inserted
If a card is removed and a different type card is inserted and this MMC is
performed, the memory associated with that card(e.g., key programming, etc.) will
be erased.
CONDITIONS
NONE
DEFAULT DATA
NONE
ACTION
1) Press Transfer button and enter 806.
Display shows:
2) Press Volume button to make selection
(e.g., Cabinet 1) and press Right Soft button.
3) To select which slot to address press.
Volume button to make selection.
OR
Use the dial pad to make a selection(e.g., Slot 6) and
press Right Soft button.
2-328
st
Power type = PSU 60)
nd
Power type = PSU 60)
st
Power type = PSU-B)
nd
Power type = PSU-B)
DISPLAY
C:1–S:1 P:1[16]
8 DLI 8 DLI
C:1–S:1 P:1[16]
8 DLI 8 DLI
C:1–S:6 P:2[16]
16 DLI 16 DLI
© SAMSUNG Electronics Co., Ltd.