Chapter 2. Mmc Programming; Overview Of Programming Procedure - Samsung OfficeServ 500 Programming Manual

CHAPTER 2.
This chapter describes how to use each MMC program as it was listed.

2.1 Overview of Programming Procedure

Here, the order of programming will be discussed before explaining programming method
of each list. Please read the description carefully before programming.
The programming order is as follows:
1) Make the programmable state.
Press the Transfer button at pause.
Enter the program number, either 200 or 800.
Enter either the operator passcode or the technician passcode.
Press 1 dial button to 'enable' the programming mode.
In case of Program 800 Technician Program Mode Setting, enter the tenant number
to be programmed.
2) Make the program number selectable state.
If the Speaker button is pressed, the program selection mode appears.
Or, if the Transfer button is pressed, the programming state ends and the pause state
begin.
3) Select a program.
Enter the program number.
Or, select the program number with the Volume button and press the Speaker button.
Or, Press Transfer button in a pause state and enter the program number.
4) Start programming the corresponding program.
© SAMSUNG Electronics Co., Ltd.
MMC Programming
OfficeServ 500 Programming Guide
2-1