Samsung OfficeServ 500 Programming Manual page 308

CHAPTER 2. Ошибка! Стиль не определен.
Field
TRUNK FOR DN2
SEPARATOR
DISCONNECT
SIGNAL
CALLER ID
NUMBER
CALL TYPE ID
2-266
Description
If set to yes, when the voice mail auto attendant system answers
a call the system will send data in the DN2 field indicating the
originating trunk of the call ringing the VMAA port.
If set to no, when the voice mail auto attendant system answers
a call the system will not send trunk data in the DN2 field
When both DN1 and DN2 are used, a digit defined here is sent
between DN1 and DN2 so the VMAA system can determine
where DN 1 stops and where DN 2 starts. The separator can be
DTMF 0 through 9, *, #, A, B or C.
This is the call progress digit sent to the VMAA port in place of a
disconnect open. The digit defined here is sent three times.
If set to yes, when the voice mail auto attendant system answers
a call the system will send Caller ID data as DTMF tones to the
VMAA port.
This is the DTMF digit that is sent first in the in band digit string
and can identify any of the following call types
No Call Type
0 DIRECT A call originating directly from another
CALL station in the system.
1 ALL FWD This indicates that a call was forwarded to
CALL the VM/AA port from a station with CALL
FORWARD ALL set.
2 BSY FWD This indicates that a call was forwarded to
CALL the VM/AA port from a station with CALL
FORWARD BUSY set.
3 NOA FWD This indicates that a call was forwarded to
CALL the VM/AA port from a station with CALL
FORWARD NO ANSWER set.
4 RECALL A call is recalling the VM/AA port after
being transferred and not answered.
5 DIR TRK A Trunk Line call has gone directly to
CALL VM/AA(e.g., trunk 717 DIL to VM/AA).
6 OVERFLOW A call has OVERFLOWED to the VM/AA
port from a station group.
7 DID CALL A DID call has called the VM/AA port.
8 MESSAGE A message button or message reply
CALL feature code has been used to call the
VM/AA port.
(Continued)
Description
© SAMSUNG Electronics Co., Ltd.
Default
No
No
C
No
-
Default
*
#
#
#
#
*
#
B
*