Samsung OfficeServ 500 Programming Manual page 424

CHAPTER 2. Ошибка! Стиль не определен.
No Option
10 FRAME
COUNT
11 JITTER BUF
12 TOS FIELD
13 S/W VERSION
14 S/W UPGRADE
15 TIME ZONE
16 PUB TO PUB
17 SIG TYPE
18 PRIVATE IP
CONDITIONS
NONE
DEFAULT DATA
SEE DESCRIPTION
2-382
Description
This value determines the transmission interval time of
VoIP packets generated by the IP phone. This data
uses case of MMC 841 ITP DSP PARA DOWN =
PHONE DATA only. The range is 10~40 ms.
Decides the minimum time to consider delay for jitter
adjustment. This data uses case of MMC 841 ITP DSP
PARA DOWN = PHONE DATA only.
The range is 10~90 ms.
An eight-bit binary value that will be utilized by external
routers, switches, etc(that optionally support TOS-bit
prioritization)-to identify the transport-priority value of
data packets generated by the IP phone. This value can
be left at default value(00000) if your network
infrastructure does not support this method of
bandwidth management. This data uses case of MMC
841 ITP DSP PARA DOWN = PHONE DATA only.
Display IP phone software version. This read only data.
This is used IP phone software upgrade request
command. When this selects YES and press Right Soft
button, the system requests to IP phone software
upgrade with TFTP IP address.
Decides time difference of IP Phone and the system.
This is for IP Phone which is installed in the different
time area of the system.
When this option is set to 'USE MGI', MGI can be
allocated between Remote ITPs in same private zone.
This option can change UDP/TCP signal type of ITPs.
(ITP V3.xx only supports TCP signal type. When ITP
V2.xx attempt to conection the TCP signal type will be
changed to UDP automatically even though user set the
TCP signal type. )
This is the Private IP address of the IP phone once
registered with the system. This is read only data.
(Continued)
Default
10 ms
20 ms
all bits 0
DISCONNECT
DISCONNECT
00:00
NOT USE MGI
UDP
0.0.0.0
© SAMSUNG Electronics Co., Ltd.