Transport Wheels And Hubs - Toro GreensPro 1240 Service Manual

Transport Wheels and Hubs

g240020
1. Wheel-lug nut (4 each)
2. Wheel and tire assembly
3. Bolt
4. Lock washer
Removing the Wheel and Hub
Installing the Wheel and Hub
Chassis: Service and Repairs
5. Collar
6. Bearing (2 each)
7. Hub assembly
8. Bearing spacer
Refer to Figure 88 for this procedure.
1. Park the machine on a clean, level surface with the transport wheels in the
raised and locked position. Shut off the engine.
2. Remove the 4 wheel-lug nuts, and remove the wheel and tire assembly from
the hub.
3. Remove the bolt, lock washer, and collar that secure the hub assembly to
the spindle, and remove the hub from the spindle.
4. Inspect the bearings in the hub assembly and replace as necessary.
Refer to Figure 88 for this procedure.
1. Clean all the components before assembly.
2. If a bearing or a drive stud (item 9) is removed, ensure that it is pressed
into position fully during installation.
3. Apply a thin coat of anti-seize lubricant to the spindle and secure the hub
assembly to the spindle with the bolt, lock washer, and collar.
4. Install the wheel and tire assembly with the 4 wheel-lug nuts and tighten the
wheel-lug nuts to 108 N∙m (80 ft-lb) in an alternating pattern.
Figure 88
10.
Page 7–50
9. Drive stud (4 each)
Spindle
GreensPro
14211SL Rev A
™ 1240/1260