Worklight Switch - Toro GreensPro 1240 Service Manual

Worklight Switch

g238112
1. Worklight switch
2. Seat pan
Testing the Worklight Switch
GreensPro ™ 1240/1260
14211SL Rev A
On GreensPro 1240 machines, the worklight switch is optional and is located on
the right side of the seat pan. On GreensPro 1260 machines, the worklight switch
is standard and is located on the right side of the seat support plate
1. Park the machine on a level surface, engage the parking brake (if equipped),
and shut off the engine.
2. Disconnect the wire harness connector from the worklight switch.
3. Check the wire harness connector for corrosion and clean the connector
if necessary.
4. Use a multimeter (ohms setting) and the following table to determine whether
continuity exists between the various terminals for each switch position.
POSITION CLOSED
CIRCUITS
OFF 2 + 3, 5 + 6
ON 2 + 1, 5 + 4
5. Replace the worklight switch if testing determines that it is damaged.
6. If the worklight switch testing is correct and a circuit problem still exists, check
the wire harness for the circuit continuity; refer to the
and Wire Harness Drawings/Diagrams (page
7. After testing, apply a film of dielectric grease to the switch terminals and
connect the machine wire harness connector to the worklight switch.
Figure 46
3. Seat support plate
Page 6–19 Electrical System: Testing the Electrical Components
(Figure
Electrical Schematics
6–3).
?).