Toro GreensPro 1240 Service Manual page 173

Disassembling the Steering Head (continued)
Assembling the Steering Head
GreensPro ™ 1240/1260
14211SL Rev A
1. Remove the cap from the roller support.
2. Remove the bolt and lock washer that secure the collar (item 10) to the pivot
shaft.
3. Lift the roller support with the bearing and collar still attached from the pivot
shaft.
4. Remove the fasteners that secure the bearing to the roller support. Separate
the bearing from the roller support and remove the collar.
5. Remove the spacer from the pivot shaft.
6. Remove the pivot shaft if necessary.
7. Repair or replace the steering head assembly components as necessary.
Refer to Figure 86 for this procedure.
1. Install the pivot shaft if previously removed.
2. Apply a thin coat of anti-seize lubricant to the pivot shaft and install the
spacer on the pivot shaft.
3. Place the collar (item 10) between the bearing and roller support and secure
the bearing to the roller support with the fasteners previously removed.
4. Fit the bearing and roller support assembly over the pivot shaft and secure
the collar to the pivot shaft with the bolt and lock washer.
5. Install the cap in the roller support.
6. Lubricate the bearing through grease fitting until the grease is visible on
outside of the bearing. Wipe away any excess grease.
Page 7–47 Chassis: Service and Repairs