Toro GreensPro 1240 Service Manual page 166

Steering Linkage (continued)
Chassis: Service and Repairs
direction. GreensPro 1260 linkage rods have a groove cut in the rod near the
end with left-hand threads.
Note: Leave the linkage rod hex nuts loose until the rod ends have been secured
and the rod length is adjusted.
The distance from the top of the steering pivot to the underside of the chassis
top plate should be 32 mm (1.25 inches) for GreensPro 1240 machines or
25 mm (1 inch) for GreensPro 1260 machines
and adjust if necessary.
After assembly, check the steering operation and adjust as necessary; refer to
Adjusting the Steering Linkage (page
g239518
1. Set screw
7–5).
Figure 81
2. Steering pivot
Page 7–40
(Figure 81). Loosen set screw
GreensPro
14211SL Rev A
™ 1240/1260