Toro GreensPro 1240 Service Manual page 144

Motion Control Linkage (GreensPro 1260) (continued)
Chassis: Service and Repairs
The entire motion control linkage assembly must be secure and move freely in
both directions. The motion control pedals should contact the pedal stop bolts
just before the control arm assembly reaches the end of its rotation (in both
directions). Repair or replace the motion control linkage assembly components
as necessary (Figure 66).
Use a suitable lifting device to safely raise and support the machine
to get access to the components under the chassis.
Both of the linkage rod ends have right-hand threads. One of the linkage rod
ends must be disconnected from the machine to adjust the linkage rod length.
Note: Leave the linkage rod hex nuts loose until the rod ends have been secured
and the rod length is adjusted.
After assembly, check the hydraulic pump and motion control pedal return to
neutral operation and adjust as necessary; refer to
Return to Neutral Mechanism (page
CAUTION
5–29).
Page 7–18
Adjusting the Control Pedal
GreensPro ™ 1240/1260
14211SL Rev A