Adjustments; Adjustments; Adjusting Transmission For Neutral; Adjusting Transport Speed - Toro Greensmaster 3200 Service Manual

Adjustments

Adjusting Transmission for Neutral

If the machine "creeps" when the traction control pedal
is in the neutral position, the neutral return mechanism
must be adjusted.
1. Block up under the frame so one of the front wheels
is off the floor.
2. Start engine, move throttle to SLOW and check front
wheel that is off shop floor; it must not be rotating.
3. If wheel is rotating, stop engine and proceed as fol-
lows:
A. Loosen both jam nuts securing traction control
cable to bulkhead on hydrostat. Make sure jam nuts
are loosened equally and sufficiently to allow adjust-
ment.
B. Loosen nut securing eccentric to top of hydros-
tat.
C. Move functional control lever to neutral, throttle
to slow and start engine.
D. Rotate eccentric until creep does not occur in ei-
ther direction. When wheel stops rotating, tighten
nut locking eccentric and adjustment. Verify the ad-
justment with throttle in SLOW and FAST position.

Adjusting Transport Speed

The traction pedal is adjusted for maximum transport
speed at the factory, but an adjustment may be required
if pedal reaches full stroke before it contacts pedal stop,
or if a decrease in transport speed is desired.
1. Press down on traction pedal and see if pedal con-
tacts stop before tension is felt on cable. If an adjustment
is required:
A. Loosen flange head locknuts securing pedal
stop to floor plate.
B. Adjust pedal stop so it contacts pedal rod before
minimum tension is felt on the cable. Tighten nuts.
Hydraulic System
E. From each side of bulkhead, tighten locknuts
evenly, securing traction cable to bulkhead. Do not
twist cable.
Note: If cable tension exists when in neutral, machine
may creep when the functional control lever is moved
to the Mow or Transport position.
3
1
1. Traction control cable
2. Bulkhead
3. Jam nuts
1. Pedal stop
Page 5 – 38
5
4
2
Figure 11
4. Eccentric
5. Lock nut
Figure 12
2. Floor plate
Greensmaster 3200/3200–D