Toro GreensPro 1240 Service Manual page 181

Removing the Transport Frame (continued)
Installing the Transport Frame
GreensPro ™ 1240/1260
14211SL Rev A
9. Support the hitch end of the transport frame and remove the bolts, lock
washers, flat washers, clamp plates, and upper halves of the clamps from
the chassis.
The weight of the transport frame assembly is approximately 47 kg
(104 lb).
10. Use a suitable lifting device to safely lift the transport frame assembly from
the chassis.
Refer to Figure 89 for this procedure.
1. Use a suitable lifting device to safely lift the transport frame assembly onto
the chassis.
2. Center the transport frame over chassis left to right and secure the transport
frame to the chassis with the bolts, lock washers, flat washers, clamp plates,
and clamps. Tighten the clamp bolts from 18 to 24 N∙m (13 to 18 ft-lb).
3. Move the transport frame past the latch and install the gas spring (item 3) to
the transport frame.
4. Install the damper (item 2) to the transport frame.
5. Secure the latch lever to the transport frame with the fasteners previously
removed.
6. Install the seat support to the chassis with seat, seat pan, manual tube, etc.
attached. Secure the seat support to the chassis and rear support frame with
the fasteners previously removed.
7. Connect the parking brake cable if equipped.
8. Connect the main wire harness at the following locations:
A. Hour meter harness
B. Interlock module (machine serial number above 315000000)
C. Seat switch (machine serial number above 315000000)
D. Parking brake switch (machine serial number above 315000000)
9. Install the transmission cover to the machine; refer to
Transmission Cover (page
10. Check the transport frame for proper latch and lift pedal operation before
returning the machine to service; refer to the Operator's Manual.
CAUTION
7–59).
Page 7–55
Installing the
Chassis: Service and Repairs