Steering Wheel - Toro GreensPro 1240 Service Manual

Steering Wheel

Removing the Steering Wheel
Installing the Steering Wheel
GreensPro ™ 1240/1260
14211SL Rev A
g239308
1. Steering wheel cover
2. Locknut
3. Flat washer
Refer to Figure 76 for this procedure.
1. Park the machine on a clean, level surface with the transport wheels in the
raised and locked position. Shut off the engine. Engage the parking brake if
equipped, or remove the spark plug wire from the spark plug.
2. Remove the steering wheel cover from the steering wheel by carefully prying
up on one of the cover spokes.
3. Remove the locknut and flat washer that secure the steering wheel to the
steering column.
4. Remove the steering wheel from the steering column. Use a suitable puller
if necessary.
Refer to Figure 76 for this procedure.
1. Clean the tapered surfaces of the steering wheel and steering column.
2. Apply a thin coat of anti-seize lubricant to the splines of steering column and
ensure to keep the anti-seize lubricant from the steering column taper. Slide
the steering wheel onto the steering column.
Figure 76
4. Steering wheel
5. Steering column
Page 7–33 Chassis: Service and Repairs