Toro GreensPro 1240 Service Manual page 76

Adjusting Procedure for GreensPro 1240 (continued)
Hydraulic System: Adjustments
g241035
1. Transmission
2. Damper
3. Linkage rod
4. Transmission control arm
5. Damper plate
6. Lock washer
5. Start the engine and set the throttle to full engine speed.
6. For machines with a serial number above 315000000, have an assistant sit
in the operator's seat and disengage the parking brake.
7. If the drive roller does not rotate, shut off the engine and attach the linkage
rod to the transmission control arm.
8. If the drive roller rotates, note the direction of drive roller rotation, then shut
off the engine and adjust the transmission control arm assembly as follows
(Figure 26):
A. Loosen the RTN (Return To Neutral) adjustment screw until the control
arm assembly can be rotated.
Figure 25
GreensPro 1240
7. Hex nut
8. Bolt (2 each)
9. Flat washer (4 each)
10. Spacer (linkage arm)
11. Spacer (damper plate)
12. Locknut (2 each)
Page 5–30 GreensPro ™ 1240/1260
14211SL Rev A