Steering Column
g239519
1.
Steering column boot
2.
Bearing cover
3.
Steering column
4.
Bolt (4 each)
5.
Flat washer (4 each)
6.
Pivot pin (2 each)
7.
E-ring (4 each)
Removing the Steering Column
GreensPro
™
1240/1260
14211SL Rev A
8.
Gas spring assembly
9.
Flange nut (4 each)
10.
Flat washer
11.
Locknut
12.
Steering pivot
13.
Flat washer
14.
Steering pivot linkage rod
Refer to
Figure 77
for this procedure.
Use a suitable lifting device to safely raise and support the machine
to get access to the components under the chassis.
1. Remove the steering wheel; refer to
7–33).
2. Remove the bearing cover from the top of the steering column.
3. Remove the steering column boot as follows:
A. Set the steering column tilt to the fully rearward position.
B. Gently pull the steering column boot over the tilt control lever.
Figure 77
15.
16.
17.
18.
19.
CAUTION
Removing the Steering Wheel (page
Page 7–35
Bolt
Woodruff key
Steering pivot rod
Steering pivot
Set screw
Chassis: Service and Repairs