Test Procedure (continued)
GreensPro
™
1240/1260
14211SL Rev A
Before opening the hydraulic system, press the motion control
pedals to release the pressure in the system and avoid injury from
the pressurized hydraulic fluid.
4. Clean the junction of the hydraulic hoses and straight fittings at the hydraulic
pump
(Figure
22). Tag the hoses to correspond with the pump ports (A and
B) then disconnect the hoses from the fittings. Plug the hoses to prevent
contamination from entering the system.
g274728
1.
Hydraulic pump
2.
Charge circuit test port
3.
Pump A port (travel right)
5. Remove the hydraulic fitting from the hydraulic pump B port. Plug pump B
port with a #8 SAE hydraulic plug.
6. Remove the plug from the charge circuit test port and install a male test
connector.
7. Install a #8 ORFS elbow and a male test connector to the hydraulic pump A
port.
CAUTION
Figure 22
4.
Pump B port (travel left)
5.
Pressure gauge – 0 to 500 psi
6.
Pressure gauge – 0 to 5000 psi
Page 5–23
Hydraulic System: Testing the Hydraulic System