Adjusting The Rake Stop Bolts; Using Drag Weights; Setting The Transport Position; Inspecting And Cleaning The Rake And Traction Unit - Toro Sand Pro 3040 Operator's Manual

Loosen the trowel mounting screws, move the trowel
up or down to the desired position, and tighten the
screws (Figure 12).
Figure 12
1. Trowel
Adjusting the Rake Stop
Bolts
Loosen the jam nuts and rotate the rake stop bolts
(Figure 13) out to limit the side to side pivoting of the
rake. Tighten the jam nuts to lock the adjustment.
Figure 13
1. Stop bolt (2)

Using Drag Weights

You can attach optional weights onto the finishing
rakes if the sand is damp or coarse or if there are
deep footprints in the traps. Order Part No. 18-7570
from your authorized Toro distributor.
g003411
2. Mounting screws
g262219
2. Jam nut (2)
Setting the Transport
Position
Complete the following procedure to increase the
height of the rake when transporting:
1. Lower the rake and lift assembly as low as
possible.
2. Disconnect the chains from the lift arms and
reconnect them higher.
Note:
To ensure proper operation of rake, return the
chains to the original slack position before operating
the rake.
Inspecting and Cleaning
the Rake and Traction Unit
After raking, clean the machine thoroughly. Because
you use this machine primarily in sand and sand is
extremely abrasive, wash off the sand after each use.
If you clean the machine frequently (before the sand
has a chance to cake), clean it with a stream of water
from a hose with the nozzle removed. A high-pressure
stream could drive the sand into wear areas, where it
could act as a grinding compound.
Note:
If the attachment adapter sticks to the traction
unit adapter, insert a pry bar or screwdriver into the
pry slot to disengage the parts
1. Pry slot
10
(Figure 14).
Figure 14
g003783