Toro GreensPro 1240 Service Manual page 93

Installing the Transmission (continued)
GreensPro ™ 1240/1260
14211SL Rev A
g241040
1. Set screw
2. Key
2. Place the transmission in position on the chassis.
3. Apply a thin coat of anti-seize lubricant to the transmission output shaft.
4. Position the sprocket in the drive chain. Move the transmission toward the
mounting bracket while guiding the sprocket onto the output shaft.
5. Secure the transmission to the mounting bracket and lower the transmission
mount with the bolts, locknuts, and flat washers.
6. Secure the sprocket to the transmission output shaft with the retaining ring
(item 11 in Figure 34).
Note: If the idler arm assembly requires service; refer to
Arm (GreensPro 1240) (page
7. Install the flat washer and hex nut (item 14 and 15 in
adjustment rod. Thread the nut 32 mm (1.25 inches) onto the rod.
8. Install the idler arm assembly with the bolt, flat washers, pivot bushing,
spacer, and locknut. Do not adjust the idler adjustment rod (chain tension)
at this time.
9. Install the compression spring (item 3 in
on the idler adjustment rod.
10. Connect the transmission collar to the drive coupling (item 1 in
with the bolts, flat washers, spacers, and locknuts. Tighten the locknuts to 23
to 29 N∙m (17 to 21 ft-lb).
To prevent damage to the drive coupling, ensure that no distortion
of coupling exists after securing the transmission collar to the
coupling. If coupling distortion is evident, loosen the transmission
and/or engine and position the transmission and/or engine on frame
so that the coupling is not distorted.
11. Tighten the transmission drive collar set screw.
Figure 35
3. Fan
4. Drive collar
7–13).
Figure
IMPORTANT
Page 5–47
Drive Chain Idler
Figure 34) on the idler
34), spacer, and hex nut
Figure
Hydraulic System: Service and Repairs
33)