Toro GreensPro 1240 Service Manual page 99

Installing the Hydraulic Pump
GreensPro ™ 1240/1260
14211SL Rev A
Refer to Figure 37 for this procedure.
1. If the hydraulic fittings were removed from the pump, lubricate and install
new O-rings to the fittings. Install the fittings into the pump; refer to
the Hydraulic Fittings (page
Ensure that you do not damage the machine components while
installing the hydraulic pump.
2. Position the square key (item 4 in
pump shaft.
3. Insert the hydraulic pump shaft into the hydraulic pump drive collar through
the engine plate.
4. Secure the hydraulic pump to the engine plate with the 2 bolts (item 7 in
Figure 37), 4 plain washers, and 2 nuts.
5. Remove the caps and plugs from the hydraulic hoses and fittings.
6. Use the labels that you attached during the removal process to correctly
connect the hydraulic hoses to the fittings on the hydraulic pump; refer to
Installing the Hydraulic Hoses and Tubes (page
7. Secure the neutral switch (item 17 in
slotted-head screws and tapped plate.
8. Connect the wire harness electrical connector to the neutral switch.
9. Position the traction cable and bushing to the hydraulic pump control arm
and secure the traction cable to the control arm with the flange-head screw
(item 13 in Figure 37), flat washer, and flange nut.
10. Install the transmission cover to the machine; refer to
(page 7–58).
11. Check the hydraulic fluid level in the hydraulic tank and add correct quantity
of fluid if necessary; refer to the Operator's Manual.
12. Operate the machine functions slowly until air is out of system; refer to
Charging the Hydraulic System (page
13. Check the hydraulic pump and motion control pedal return to neutral
operation and adjust as necessary; refer to
Return to Neutral Mechanism (page
5–14).
IMPORTANT
Figure 37) to the key slot in the hydraulic
Figure
5–42).
5–29).
Page 5–53
5–12).
37) to the control arm with the 2
Transmission Cover
Adjusting the Control Pedal
Hydraulic System: Service and Repairs
Installing