GE N60 Instruction Manual page 221

CHAPTER 5: SETTINGS
Module Channel
76 Channel 1
77 Channel 1
Channel 2
75 Channel 1
Channel 2
7E Channel 1
Channel 2
7F Channel 1
Channel 2
7G Channel 1
Channel 2
7Q Channel 1
Channel 2
7R Channel 1
7S Channel 1
Channel 2
The G.703 modules are fixed at 64 kbps. The
NOTE
The
DIRECT I/O CHANNEL CROSSOVER
over messages from channel 1 to channel 2. This places all UR-series IEDs into one direct input and output network
regardless of the physical media of the two communication channels.
The following application examples illustrate the basic concepts for direct input and output configuration. See the Inputs
and Outputs section in this chapter for information on configuring FlexLogic operands (flags, bits) to be exchanged.
Example 1: Extending the input/output capabilities of a UR-series relay
Consider an application that requires additional quantities of contact inputs or output contacts or lines of programmable
logic that exceed the capabilities of a single UR-series chassis. The problem is solved by adding an extra UR-series IED,
such as the C30, to satisfy the additional input and output and programmable logic requirements. The two IEDs are
connected via single-channel digital communication cards as shown in the figure.
Figure 5-40: Input and output extension via direct inputs and outputs
In this application, apply the following settings. For UR-series IED 1:
DIRECT OUTPUT DEVICE ID: "1"
DIRECT I/O CH1 RING CONFIGURATION: "Yes"
DIRECT I/O DATA RATE: "128 kbps"
For UR-series IED 2:
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
Supported data rates
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
64 kbps
DIRECT I/O DATA RATE
setting applies to N60s with dual-channel communication cards and allows crossing
TX1
UR IED 1
RX1
TX1
UR IED 2
RX1
842711A1.CDR
setting is not applicable to these modules.
PRODUCT SETUP
5
5-105