GE N60 Instruction Manual page 110

FRONT PANEL INTERFACE
buttons.
4
4.2.8.2 Standard faceplate
Custom labeling of an LED-only panel is facilitated through a Microsoft Word file available from the following URL:
http://www.gedigitalenergy.com/products/support/ur/GET-8494A.doc
This file provides templates and instructions for creating appropriate labeling for the LED panel. The following procedures
are contained in the downloadable file. The panel templates provide relative LED locations and located example text (x)
edit boxes. The following procedure demonstrates how to install/uninstall the custom panel labeling.
1. Remove the clear Lexan Front Cover (GE part number: 1501-0014).
2. Pop out the LED module and/or the blank module with a screwdriver as shown. Be careful not to damage the plastic
covers.
3. Place the left side of the customized module back to the front panel frame, then snap back the right side.
4-24
F60 F60 F60 F60
FEEDER MANAGEMENT RELAY FEEDER MANAGEMENT RELAY FEEDER MANAGEMENT RELAY FEEDER MANAGEMENT RELAY R
( LED MODULE )
F60 FEEDER MANAGEMENT RELAY R
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
Push in
and gently lift
up the cover.
842771A1.CDR
( BLANK MODULE )
842722A1.CDR
CHAPTER 4: INTERFACES