GE N60 Instruction Manual page 129

CHAPTER 5: SETTINGS
5.3.1.3 EnerVista security
Enabling the security management system
The EnerVista security system allows an administrator to manage access privileges of multiple users of EnerVista.
It is disabled by default to allow the administrator to access EnerVista software immediately after installation. When
security is disabled, all users have administrator access. GE recommends enabling the EnerVista security before placing
the device in service.
To enable the security system and require password use:
1. Select the Security > User Management menu item to open the user management window.
2. Check the Enable Security check box in the lower-left corner to enable the security management system.
If you force password entry by using this feature, ensure that you know the Administrator password. If you do
not know the password and are locked out of the software, contact GE Digital Energy for the default password
NOTE or a UR device. When using CyberSentry, the default password is "ChangeMe1#".
Security is now enabled for the EnerVista UR Setup software. Upon starting the software, users are now required to enter a
username and password.
Add a new user
The following pre-requisites are required to add user accounts to the EnerVista security management system:
• The user adding the account must have administrator rights
• The EnerVista security management system must be enabled (previous section)
To add a user account:
1. Select the Security > User Management item from the top menu to open the user management window.
2. Enter a username in the User field. The username must be 4 to 20 characters in length.
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
PRODUCT SETUP
5
5-13