GE N60 Instruction Manual page 138

PRODUCT SETUP
LOAD FACTORY DEFAULTS
Administrator role is used to change this setting and a Supervisor role (if not disabled) approves it.
Supervisory
SETTINGS  PRODUCT SETUP  SECURITY  SUPERVISORY
 SUPERVISORY

The Supervisory menu settings are available for Supervisor role only, or if the Supervisor role is disabled then for the
Administrator role only.
5
DEVICE AUTHENTICATION —
authentication with roles is enabled. When this setting is disabled, the UR only authenticates to the AAA server (RADIUS).
However, the Administrator and Supervisor (when enabled) remain active even after device authentication is disabled and
their only permission is to re-enable Device authentication. To re-enable Device authentication, the Supervisor unlocks the
device for settings changes, then the Administrator re-enables device authentication.
— The bypass security feature provides an easier access, with no authentication and encryption for those
BYPASS ACCESS
special situations when this is considered safe. Only the Supervisor, or the Administrator when the Supervisor role is
disabled, can enable this feature.
Mode
Normal mode
Bypass access mode
The bypass options are as follows:
• Local — Bypasses authentication for push buttons, keypad, RS232, and RS485
• Remote — Bypasses authentication for Ethernet
• Local and Remote — Bypasses authentication for push buttons, keypad, RS232, RS485, and Ethernet
— This setting uses a Boolean value (Enabled/Disabled) to indicate if the device accepts settings changes and
LOCK RELAY
whether the device can receive a firmware upgrade. This setting can be changed by the Supervisor role, if it is enabled, or
by the Administrator if the Supervisor role is disabled. The Supervisor role disables this setting for the relay to start
accepting settings changes, command changes, or firmware upgrade. After all the setting changes are applied or
commands executed, the Supervisor enables to lock settings changes.
Example: If this setting is enabled and an attempt is made to change settings or upgrade the firmware, the UR device
denies the settings changes or denies upgrading the firmware. If this setting is disabled, the UR device accepts settings
changes and firmware upgrade.
This role is disabled by default.
5-22
— This setting is used to reset all the settings, communication, and security passwords. An
DEVICE

AUTHENTICATION: Yes
BYPASS ACCESS:

Disabled
LOCK RELAY:

Disabled
FACTORY SERVICE

MODE: Disabled
 SELF TESTS


SUPERVISOR ROLE:

Disabled
SERIAL INACTIVITY

TIMEOUT: 1 min
This setting is enabled by default, meaning "Yes" is selected. When enabled, Device
Front panel or serial (RS232, RS485)
Authentication — Role Based Access Control (RBAC)
and passwords in clear
No passwords for allowed RBAC levels
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
Range: Yes, No
Range: Local, Remote, Local and Remote, Disabled
Range: Enabled, Disabled
Range: Enabled, Disabled
See below
Range: Enabled, Disabled
Range: 1 to 9999 minutes
Ethernet
Authentication — RBAC and passwords encrypted
SSH tunneling
No passwords for allowed RBAC levels
No SSH tunneling