Event Viewing; File Support; Enervista Main Window - GE N60 Instruction Manual

ENERVISTA SOFTWARE INTERFACE
• Testing
Factory default values are supplied and can be restored after any changes.
The following communications settings are not transferred to the N60 with settings files:
Modbus Slave Address
Modbus TCP Port Number
RS485 COM2 Baud Rate
RS485 COM2 Parity
COM2 Minimum Response Time
COM2 Selection
RRTD Slave Address
RRTD Baud Rate
IP Address
IP Subnet Mask
IP Routing
When a settings file is loaded to a N60 that is in-service, the following sequence occurs:
1. The N60 takes itself out of service.
4
2. The N60 issues a UNIT NOT PROGRAMMED major self-test error.
3. The N60 closes the critical fail contact.
The Maintenance chapter outlines how to use a settings file in the .urs format for backup and restore.

4.1.3 Event viewing

While the interface is in either online or offline mode, you can view and analyze data generated by triggered parameters,
via one of the following:
• Event recorder — The event recorder captures contextual data associated with the last 1024 events, listed in
chronological order from most recent to oldest
• Oscillography — The oscillography waveform traces and digital states are used to provide a visual display of power
system and relay operation data captured during specific triggered events

4.1.4 File support

The following support applies, where the Settings List is at the bottom left and the Site List is at the top left of the EnerVista
window:
• Execution — Any EnerVista UR Setup file that is opened launches the application or provides focus to the already
opened application. If the file was a settings file (has a .urs extension) that had been removed from the Settings List
navigation menu, it is added back to the menu.
• Drag and Drop — The Site List and Settings List control bar windows are each mutually a drag source and a drop
target for device-order-code-compatible files or individual menu items. Also, the Settings List control bar window and
any Windows Explorer directory folder are each mutually a file drag source and drop target.
New files that are dropped into the Settings List window are added to the tree, which is automatically sorted
alphabetically with respect to settings file names. Files or individual menu items that are dropped in the selected
device menu in the Site List window are automatically sent to the online communicating device.

4.1.5 EnerVista main window

The EnerVista UR Setup software window has the following components:
1. Title bar that shows the pathname of the active data view or the name of the software
2. Main window menu bar
3. Main window tool bar
4-2 N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES