Output Mode - ABB ACS350 User Manual

72

Output mode

In the Output mode, you can:
• monitor actual values of up to three signals in group
• change the direction of the motor rotation
• set the speed, frequency or torque reference
• adjust the display contrast
• start, stop, change the direction and switch between local and remote control.
You get to the Output mode by pressing
The top right corner of the
display shows the reference
value. The center can be
configured to show up to three
signal values or bar graphs; see
page
selecting and modifying the monitored signals.
How to change the direction of the motor rotation
Step Action
1. If you are not in the Output mode, press
2. If the drive is in remote control (REM shown on the status line), switch to local
control by pressing
the mode and then returns to the Output mode.
3. To change the direction from forward ( shown on the status line) to reverse (
shown on the status line), or vice versa, press
Note: Parameter
Control panels
75 for instructions on
. The display briefly shows a message about changing
LOC
REM
1003 DIRECTION must be set to 3 (REQUEST).
EXIT repeatedly.
LOC
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00
EXIT
repeatedly until you get there.
DIR
.
01 OPERATING DATA
49.1Hz LOC
HZ
0. 4 A
24. 4 %
MENU DIR 00:00
Display
REM
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00
LOC
49. 1 Hz
0. 5 A
10. 7 %
DIR 00:00
5.0Hz
50%
MENU
49.1Hz
MENU
49.1Hz
MENU