84 Sequence Prog - ABB ACS350 User Manual

228
Parameters – complete descriptions
Index Name/Selection

84 SEQUENCE PROG

8401 SEQ PROG ENABLE
DISABLED
EXT2
EXT1
EXT1&EXT2
ALWAYS
8402 SEQ PROG START
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
NOT SEL
DI1
DI2
DI3
DI4
DI5
DRIVE START
TIMED FUNC 1
TIMED FUNC 2
TIMED FUNC 3
TIMED FUNC 4
RUNNING
Actual signals and parameters
Description
Sequence programming. See section
Enables sequence programming.
If sequence programming enable signal is lost, the sequence programming is
stopped, sequence programming state
and all timers and outputs (RO/TO/AO) are set to zero.
Disabled
Enabled in external control location 2 (EXT2)
Enabled in external control location 1 (EXT1)
Enabled in external control locations 1 and 2 (EXT1 and EXT2)
Enabled in external control locations 1 and 2 (EXT1 and EXT2) and in local
control (LOCAL)
Selects the source for the sequence programming activation signal.
When sequence programming is activated, the programming starts from the
previously used state.
If sequence programming activation signal is lost, the sequence
programming is stopped and all timers and outputs (RO/TO/AO) are set to
zero. Sequence programming state
unchanged.
If start from the first sequence programming state is required, the sequence
programming must be reset by parameter
from the first sequence programming state is always required, reset and start
signal sources must be through the same digital input
PROG START).
Note: The drive will not start if no Run Enable signal is received
ENABLE).
Sequence programming activation through inverted digital input DI1.
0 = active, 1 = inactive.
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
No sequence programming activation signal
Sequence programming activation through digital input DI1. 1 = active,
0 = inactive.
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Sequence programming activation at drive start
Sequence programming is activated by time function 1. See parameter group
36 TIMED FUNCTIONS.
See selection TIMED FUNC 1.
See selection TIMED FUNC 1.
See selection TIMED FUNC 1.
Sequence programming is always active.
Sequence programming
(0168 SEQ PROG STATE) is set to 1
(0168 SEQ PROG STATE) remains
8404 SEQ PROG RESET. If start
(8404 and
Def, FbEq
on page 133.
DISABLED
0
1
2
3
4
NOT SEL
8402 SEQ
(1601 RUN
-1
-2
-3
-4
-5
0
1
2
3
4
5
6
7
8
9
10
11