ABB ACS350 User Manual page 64

64
How to select the monitored signals
Step Action
1. You can select which signals are monitored in the Output mode and how
they are displayed with group
63 for detailed instructions on changing parameter values.
By default, the display shows three signals. The particular default signals
depend on the value of parameter
whose default value of parameter
1 (VECTOR:SPEED), the default for signal 1 is
0103 OUTPUT FREQ. The defaults for signals 2 and 3 are always
CURRENT and
To change the default signals, select up to three signals from group
OPERATING DATA
Signal 1: Change the value of parameter
index of the signal parameter in group
the parameter without the leading zero), e.g. 105 means parameter
TORQUE. Value 100 means that no signal is displayed.
Repeat for signals 2
PARAM). For example, if
only the signal specified by
parameters are set to 0, i.e. no signals are selected for monitoring, the
panel displays text "n.A".
2. Specify the decimal point location, or use the decimal point location and
unit of the source signal [setting (9 (DIRECT)]. Bar graphs are not available
for Basic Operation Panel. For details, see parameter 3404.
Signal 1: parameter
Signal 2: parameter
Signal 3: parameter
3. Select the units to be displayed for the signals. This has no effect if
parameter 3404/3411/3418
parameter 3405.
Signal 1: parameter
Signal 2: parameter
Signal 3: parameter
4. Select the scalings for the signals by specifying the minimum and
maximum display values. This has no effect if parameter
set to 9 (DIRECT). For details, see parameters
Signal 1: parameters
Signal 2: parameters
Signal 3: parameters
Control panels
34 PANEL DISPLAY
9902 APPLIC MACRO: For macros
9904 MOTOR CTRL MODE is
0105 TORQUE, respectively.
to be shown.
01 OPERATING DATA
(3408 SIGNAL2 PARAM) and 3
3401 = 0 and 3415
3408 appears in the display. If all three
3404 OUTPUT1 DSP FORM
3411 OUTPUT2 DSP FORM
3418 OUTPUT3 DSP FORM.
is set to 9 (DIRECT). For details, see
3405 OUTPUT1 UNIT
3412 OUTPUT2 UNIT
3419 OUTPUT3 UNIT.
3406 OUTPUT1 MIN and
3413 OUTPUT2 MIN and
3420 OUTPUT3 MIN and
parameters. See page
0102 SPEED, otherwise
3401 SIGNAL1 PARAM to the
(= number of
(3415 SIGNAL3
= 0, browsing is disabled and
3404/3411/3418
3406 and 3407.
3407 OUTPUT1 MAX
3414 OUTPUT2 MAX
3421 OUTPUT3 MAX.
Display
LOC
LOC
LOC
0104
01
0105
LOC
LOC
LOC
is
5000
LOC
103
PAR SET FWD
104
PAR SET FWD
105
PAR SET FWD
9
PAR SET FWD
3
PAR SET FWD
00
.
Hz
PAR SET FWD
.
Hz
PAR SET FWD