Actual signals and parameters
What this chapter contains
The chapter describes the actual signals and parameters and gives the fieldbus
equivalent values for each signal/parameter.
Terms and abbreviations
Term
Actual signal
Def
Parameter
FbEq
Fieldbus addresses
For FPBA-01 Profibus Adapter, FDNA-01 DeviceNet Adapter and FCAN-01
CANopen Adapter, see the fieldbus adapter user's manual.
Fieldbus equivalent
Example: If
of 1 corresponds to 0.1%. All the read and sent values are limited to 16 bits
(-32768...32767).
Definition
Signal measured or calculated by the drive. Can be monitored by the user. No
user setting possible. Groups 01...04 contain actual signals.
Parameter default value
A user-adjustable operation instruction of the drive. Groups 10...99 contain
parameters.
Note: Parameter selections are shown on the basic control panel as integer
values. E.g. parameter 1001 EXT1 COMMANDS selection COMM is shown as
value 10 (which is equal to the fieldbus equivalent FbEq).
Fieldbus equivalent: The scaling between the value and the integer used in
serial communication.
2017
MAX TORQ 1 is set from external control system, an integer value
Actual signals and parameters
141