Assistant Control Panel; Features; Overview - ABB ACS350 User Manual

Assistant Control Panel

Features

The Assistant Control Panel features:
• alphanumeric control panel with an LCD display
• language selection for the display
• Start-up Assistant to ease drive commissioning
• copy function – parameters can be copied to the control panel memory for later
transfer to other drives or for backup of a particular system.
• context sensitive help
• real time clock.

Overview

The following table summarizes the key functions and displays on the Assistant
Control Panel.
1
2a
LOC 49.1Hz
LOC 400RPM
49 . 1 Hz
1200 RPM
0 . 5 A
2b
12.4 A
10 . 7 %
405 dm3/s
2c
DIR DIR 00:00 12:45 MENU
3
5
7 6
9
No. Use
1 Status LED – Green for normal operation. If LED is flashing, or red, see
section
2 LCD display – Divided into three main areas:
a. Status line – variable, depending on the mode of operation, see section
Status line
b. Center – variable; in general, shows signal and parameter values, menus or
lists. Shows also faults and alarms.
MENU
c. Bottom line – shows current functions of the two soft keys and, if enabled,
the clock display.
4
3 Soft key 1 – Function depends on the context. The text in the lower left corner
of the LCD display indicates the function.
8
4 Soft key 2 – Function depends on the context. The text in the lower right
corner of the LCD display indicates the function.
10
5 Up –
• Scrolls up through a menu or list displayed in the center of the LCD display.
• Increments a value if a parameter is selected.
• Increments the reference value if the upper right corner is highlighted.
Holding the key down changes the value faster.
6 Down –
• Scrolls down through a menu or list displayed in the center of the LCD
display.
• Decrements a value if a parameter is selected.
• Decrements the reference value if the upper right corner is highlighted.
Holding the key down changes the value faster.
7 LOC/REM – Changes between local and remote control of the drive.
8 Help – Displays context sensitive information when the key is pressed. The
information displayed describes the item currently highlighted in the center of
the display.
9 STOP – Stops the drive in local control.
10 START – Starts the drive in local control.
LEDs on page 287.
on page 68.
67
Control panels