Motor Temp Meas - ABB ACS350 User Manual

Parameters – complete descriptions
Index Name/Selection
3413 OUTPUT2 MIN
x...x
3414 OUTPUT2 MAX
x...x
3415 SIGNAL3 PARAM
0, 101...172
3416 SIGNAL3 MIN
x...x
3417 SIGNAL3 MAX
x...x
3418 OUTPUT3 DSP
FORM
3419 OUTPUT3 UNIT
3420 OUTPUT3 MIN
x...x
3421 OUTPUT3 MAX
x...x
35 MOTOR TEMP
MEAS
3501 SENSOR TYPE
NONE
1 x PT100
2 x PT100
3 x PT100
Description
Sets the minimum display value for the signal selected by parameter
SIGNAL2 PARAM. See par.
Setting range depends on parameter
Sets the maximum display value for the signal selected by parameter
SIGNAL2 PARAM. See par.
Setting range depends on parameter
Selects the third signal to be displayed on the control panel in display mode.
See par 3401 SIGNAL1 PARAM.
Parameter index in group
If value is set to 0, no signal is selected.
Defines the minimum value for the signal selected by parameter 3415. See
par. 3402 SIGNAL1 MIN.
Setting range depends on parameter
Defines the maximum value for the signal selected by parameter
SIGNAL3 PARAM. See par.
Setting range depends on parameter
Defines the format for the displayed signal selected by par.
PARAM.
See parameter 3404 OUTPUT1 DSP FORM.
Selects the unit for the for the displayed signal selected by parameter
SIGNAL3 PARAM.
See parameter 3405 OUTPUT1 UNIT.
Sets the minimum display value for the signal selected by parameter
SIGNAL3 PARAM. See par.
Setting range depends on parameter
Sets the maximum display value for the signal selected by parameter
SIGNAL3 PARAM. See par.
Setting range depends on parameter
Motor temperature measurement. See section
measurement through the standard I/O
Activates the motor temperature measurement function and selects the
sensor type. See also parameter group
The function is inactive.
The function is active. The temperature is measured with one Pt 100 sensor.
Analog output AO feeds constant current through the sensor. The sensor
resistance increases as the motor temperature rises, as does the voltage
over the sensor. The temperature measurement function reads the voltage
through analog input AI1/2 and converts it to degrees centigrade.
The function is active. Temperature is measured using two Pt 100 sensors.
See selection 1 x PT100.
The function is active. Temperature is measured using three Pt 100 sensors.
See selection 1 x PT100.
3402 SIGNAL1 MIN.
3408 setting.
3402 SIGNAL1 MIN.
3408 setting.
01 OPERATING DATA. E.g. 102 =
3415 SIGNAL 3 PARAM setting.
3402 SIGNAL1 MIN.
3415 SIGNAL3 PARAM setting.
3402 SIGNAL1 MIN.
3415 SIGNAL3 PARAM setting.
3402 SIGNAL1 MIN.
3415 setting.
Motor temperature
on page 124.
15 ANALOGUE
Def, FbEq
3408 -
-
3408 -
-
105
0102 SPEED. 1 = 1
-
-
3415 -
-
3415 SIGNAL3 DIRECT
-
3415 -
-
3415 -
-
3415 -
-
NONE
OUTPUTS.
0
1
2
3
Actual signals and parameters
209