ABB ACS350 User Manual page 185

Parameters – complete descriptions
Index Name/Selection
2106 DC CURR REF
0...100%
2107 DC BRAKE TIME
0.0...250.0 s
2108 START INHIBIT
OFF
ON
2109 EMERG STOP SEL
NOT SEL
DI1
DI2
DI3
DI4
DI5
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
2110 TORQ BOOST CURR
15...300%
2111 STOP SIGNAL DLY
0...10000 ms
Description
Defines the DC hold current. See parameter
Value in percent of the motor nominal current (parameter
CURR)
Defines the DC brake time.
Time
Enables the start inhibit function. Drive start is inhibited if,
- fault is reset.
- Run Enable signal activates while the start command is active. See
parameter 1601 RUN ENABLE.
- control mode changes from local to remote.
- external control mode switches from EXT1 to EXT2 or from EXT2 to EXT1.
Disabled
Enabled
Selects the source for the external emergency stop command.
The drive cannot be restarted before the emergency stop command is reset.
Note: The installation must include emergency stop devices and any other
safety equipment that may be needed. Pressing STOP on the drive's control
panel does NOT:
- generate an emergency stop of the motor
- separate the drive from dangerous potential.
Emergency stop function is not selected
Digital input DI1. 1 = stop along the emergency stop ramp. See parameter
2208 EMER DEC TIME. 0 = emergency stop command reset.
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Inverted digital input DI. 0 = stop along the emergency stop ramp. See
parameter 2208 EMER DEC TIME. 1 = emergency stop command reset
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Defines the maximum supplied current during torque boost. See parameter
2101 START FUNCTION.
Value in percent
Defines the stop signal delay time when parameter
is set to SPEED COMP.
Delay time
2104 DC HOLD CTL.
9906 MOTOR NOM
2102 STOP FUNCTION
Actual signals and parameters
185
Def, FbEq
30
1 = 1%
0
1 = 0.1 s
OFF
0
1
NOT SEL
0
1
2
3
4
5
-1
-2
-3
-4
-5
100
1 = 1%
0
1 = 1 ms