Settings; Diagnostics - ABB ACS350 User Manual

134
Note: As default all sequence programming parameters can be changed even when
the sequence programming is active. It is recommended, that after the sequence
programming parameters are set, parameters are locked by parameter
PARAMETER LOCK.

Settings

Parameter
1001/1002
1102
1106
1201
1401
1501
1601
1805
19 TIMER & COUNTER
36 TIMED FUNCTIONS
2201....2207
32 SUPERVISION
4010/4110/4210
84 SEQUENCE PROG

Diagnostics

Actual value
0167
0168
0169
0170
0171
Program features
Additional information
Start, stop and direction commands for EXT1/EXT2
EXT1/EXT2 selection
REF2 source
Constant speed deactivation. Constant speed always overrides the
sequence programming reference.
Sequence programming output through RO
Sequence programming output through AO
Run Enable activation/deactivation
Sequence programming output through DO
State change according to counter limit
Timed state change
Acceleration/deceleration and ramp time settings
Supervision settings
Sequence programming output as PID reference signal
Sequence programming settings
Additional information
Sequence programming status
Sequence programming active state
Current state time counter
Analog output PID reference control values
Executed sequence counter
1602