Start-Up, Control With I/O And Id Run; What This Chapter Contains; How To Start Up The Drive; How To Start Up The Drive Without A Control Panel - ABB ACS350 User Manual

Start-up, control with I/O and ID Run

What this chapter contains

The chapter instructs how to:
• perform the start-up
• start, stop, change the direction of rotation and adjust the speed of the motor
through the I/O interface
• perform an Identification Run for the drive.
Using the control panel to do these tasks is explained briefly in this chapter. For
details on how to use the control panel, refer to chapter
page 57.

How to start up the drive

How you start up the drive depends on the control panel you have, if any.
• If you have no control panel, follow the instructions given in section
up the drive without a control panel
• If you have a Basic Control Panel, follow the instructions given in section
to perform the limited start-up
• If you have an Assistant Control Panel, you can either run the Start-up
Assistant (see section
a limited start-up (see section
The Start-up Assistant, which is included in the Assistant Control Panel only,
guides you through all essential settings to be done. In the limited start-up, the
drive gives no guidance; you go through the very basic settings by following the
instructions given in the manual.

How to start up the drive without a control panel

The start-up may only be carried out by a qualified electrician.
The safety instructions given in chapter
procedure.
The drive will start up automatically at power up if the external run command is on.
Check the installation. See the checklist in chapter
Check that the starting of the motor does not cause any danger.
De-couple the driven machine if there is a risk of damage in case of incorrect direction of
rotation.
on page 45.
on page 46.
How to perform the guided start-up
How to perform the limited start-up
SAFETY
Safety must be followed during the start-up
Installation
Control panels starting on
on page 51) or perform
on page 46).
checklist.
Start-up, control with I/O and ID Run
45
How to start
How