Feature Buttons And Softkeys - Cisco 7821 Administration Manual

Feature
UCR 2008
Voice Message System
Web Access Disabled by Default

Feature Buttons and Softkeys

The following table provides information about features that are available on softkeys, features that are
available on dedicated feature buttons, and features that you need to configure as programmable feature
buttons. An "X" in the table indicates that the feature is supported for the corresponding button type or softkey.
Of the two button types and softkeys, only programmable feature buttons require configuration in Cisco IP
Phone administration.
For information about configuring programmable feature buttons, see
Table 11: Features with Corresponding Buttons and Softkeys
Feature name
Answer
Call Back
Call Forward All
Call Park
Description and more information
The Cisco IP Phones support Unified Capabilities Requirements (UCR) 2008 by providing
the following functions:
• Support for Federal Information Processing Standard (FIPS) 140-2
• Support for 80-bit SRTCP Tagging
As an IP Phone administrator, you must set up specific parameters in Cisco Unified
Communications Manager Administration.
See UCR 2008 Setup, on page
Enables callers to leave messages if calls are unanswered.
See:
• Cisco Unified Communications Manager Administration Guide, "Cisco Voice-Mail Port
Configuration" chapter
• Cisco Unified Communications Manager System Guide, "Voice Mail Connectivity to
Cisco Unified Communications Manager" chapter
Enhances security by disabling access to all web services, such as HTTP. Users can only
access web services if you enable web access.
See UCR 2008 Setup, on page
Dedicated feature
button
Cisco IP Phone 7821, 7841, and 7861 Administration Guide for Cisco Unified Communications Manager 10.0 (SIP)
129.
129.
Phone Button Templates, on page
Programmable feature
button
X
X
X
X
Feature Buttons and Softkeys
136.
Softkey
X
X
X
X
111