Set Up Ucr 2008 In Enterprise Phone Configuration; Set Up Ucr 2008 In Phone - Cisco 7821 Administration Manual

Procedure
Step 1 In Cisco Unified Communications Manager Administration, choose Device > Device Settings > Common
Phone Profile.
Step 2
Set the FIPS Mode parameter to Enabled.
Step 3 Set the SSH Access parameter to Disabled.
Step 4 Set the 80-bit SRTCP parameter to Enabled.
Step 5 Select Save.

Set Up UCR 2008 in Enterprise Phone Configuration

Use this procedure to set the following UCR 2008 parameters:
• FIPS Mode
• 80-bit SRTCP
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose System > Enterprise Phone
Configuration.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3
Set the 80-bit SRTCP parameter to Enabled.
Step 4 Select Save.

Set Up UCR 2008 in Phone

Use this procedure to set the following UCR 2008 parameters:
• SSH Access
• Web Access
Procedure
Step 1 In Cisco Unified Communications Manager Administration, choose Device > Phone.
Step 2 Set the SSH Access parameter to Disabled.
Step 3
Set the Web Access parameter to Disabled.
Step 4 Select Save.
Cisco IP Phone 7821, 7841, and 7861 Administration Guide for Cisco Unified Communications Manager 10.0 (SIP)
UCR 2008 Setup
131