Cisco 7821 Administration Manual page 128

Schedule Power Save for Cisco IP Phone
Procedure
Step 1 From the Cisco Unified Communications Manager Administration, select Device > Phone.
Step 2 Locate the phone that you need to set up.
Step 3 Navigate to the Product Specific Configuration area and set the following fields.
Table 12: PowerSave Configuration Fields
Field
Days Display Not Active
Display On Time
Display On Duration
Display Idle Timeout
Step 4 Select Save.
Cisco IP Phone 7821, 7841, and 7861 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
114
Description
Days that the display does not turn on automatically at the time specified in the
Display On Time field.
Choose the day or days from the drop-down list. To choose more than one day,
Ctrl-click each day that you want.
Time each day that the display turns on automatically (except on the days
specified in the Days Display Not Active field).
Enter the time in this field in 24 hour format, where 0:00 is midnight.
For example, to automatically turn the display on at 7:00 a.m., (0700), enter
7:00. To turn the display on at 2:00 p.m. (1400), enter 14:00.
If this field is blank, the display will automatically turn on at 0:00.
Length of time that the display remains on after turning on at the time specified
in the Display On Time field.
Enter the value in this field in the format hours:minutes.
For example, to keep the display on for 4 hours and 30 minutes after it turns on
automatically, enter 4:30.
If this field is blank, the phone will turn off at the end of the day (0:00).
If Display On Time is 0:00 and the display on duration is blank (or
Note
24:00), the display will remain on continuously.
Length of time that the phone is idle before the display turns off. Applies only
when the display was off as scheduled and was turned on by a user (by pressing
a button on the phone or lifting the handset).
Enter the value in this field in the format hours:minutes.
For example, to turn the display off when the phone is idle for 1 hour and 30
minutes after a user turns the display on, enter 1:30.
The default value is 0:30.