Factory Default Settings; Asi Out For Both Models; D9854 Advanced Program Receiver - Cisco D9854 Installation And Operation Manual

ASI Out for both models

1. Press MENU to move to the MAIN MENU.
2. Press
3. Press
4. Press
5. Press SELECT to access the ASI menu. Press
select the output mode. The factory default is "No Output". It is recommended
to set the Output Mode to MAP Svc Chans Only. Refer to Factory Default
Settings, page B-2, for information on the default settings in order to choose the
desired Output Mode. Press SELECT. Press
"RESYNC ALL?". Press SELECT. Press
Menu. Press SELECT. Use
6. Press APPLY. Press SELECT.
7. Press MENU 5 times to return to the startup menu.
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
!
to move to the Setup menu. Press SELECT.
#
to move to the Outputs menu. Press SELECT.
!
to move to the TS Out menu. Press SELECT.
#
. Press SELECT. Use
!
to select "YES" if requested to
!
to move to Descrambling Mode
"#
to select the scrambling mode. Press SELECT.
"#
to
1-7