Cisco D9854 Installation And Operation Manual page 136

Setup Menu: Outputs: TS Out: DPM
GLOBAL
Resync All:
Description:
Parameters:
Regenerate
Description:
Parameters:
Copy:
Description:
Parameters:
ASI/MOIP1
PE
Description:
Parameters:
InCh
Description:
Parameters:
PMT
Description:
Parameters:
Act
Description:
Parameters:
OutCh
Description:
Parameters:
4-74 Model D9854 Advanced Program Receiver Installation and Operation Guide
This resynchronizes all DPM output with the PMT data for all
program entries.
ASI or MOIP1.
This selects whether to regenerate the PSI tables.
Always or As Needed (only if the content has changed).
This copies all DPM data from either the ASI output to the MOIP1
output (MPEG over IP) or from the MOIP1 output to the ASI output
depending on your selection.
ASI->MOIP1 or MOIP1->ASI.
This selects the DPM Program Entry to view/modify.
1 to 16.
Displays the input channel of the current PE.
1 to 65535.
This is the input PMT. This value is only to map to the output PMT
if the PE Action is set to MAP.
1 to 8192.
Selects the DPM program action for the PE.
Pass, Map or Drop. Default is Pass.
This selects the DPM output channel you want to map to the input
channel (InCh). This value is only used if the PE Action is set to
MAP.
0 to 65535.
4021470 Rev D