Configuring User Settings - Cisco D9854 Installation And Operation Manual

Configuring User Settings

To Configure your user settings
Proceed as follows to configure your user settings:
1. From the user interface of the D9854, click the Setup tab, and then the User
Settings icon from the sub-page.
2. Set the Date Format of the receiver. The following formats are supported:
YYYY_MM_DD, DD_MM_YYYY, MM_DD_YYYY.
3. Set the Time Format of the receiver. Time information is normally broadcast as
part of the transmitted digital signal. It is usually the broadcasters local time
relative to GMT (Greenwich Mean Time). The following formats are supported:
24Hr, 24 Hr SuspendZero (the leading zero is dropped from the time), 12Hr,
12Hr SuspendZero (the leading zero is dropped from the time).
4. Set the GMT Offset. The time is displayed using a time zone instead of the true
local time. If the current broadcast time is not your local time, you must change
this time setting in the range from -12.0 to +12.0 hours in 0.5 hour increments.
5. Select the KB Lock enable to set the front panel keypad lock state (Enabled or
Disabled).
6. KB Lock Timeout sets the keypad lock timeout period. The lock timeout period
takes effect when the keypad has not been touched (i.e., a key has not been
pressed) when on the Main Menu for the set period. Avoid setting the period to
a short duration when the keypad is used often. Enter a value in the range from
5 to 1800 seconds. The default is 60 seconds.
7. Set whether alarms and warnings are to be displayed on the on-screen display
(e.g., TV monitor) in OSD Banner (Enable or Disable).
5-64 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D