Cisco D9854 Installation And Operation Manual page 97

Setup Menu: TS Input,
L-Band
Description:
Parameters:
RF Lock
Description:
Parameters:
Modulation
Description:
Parameters:
Rolloff
Description:
Parameters:
InputIQ
Description:
Parameters:
NetID
Description:
Parameters:
LNB Power
Description:
Parameters:
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Continue
This is the L-Band operating frequency used by the receiver. This
value is determined by the values set in the Freq and LO options.
950 to 2150 MHz.
Indicate whether the receiver is locked to the received signal.
Lock or NoLock.
Sets the modulation type for the received signal.
DVB-S or DVB-S2.
Sets the rolloff factor of the incoming signal.
.20, .25, .35. Use .20 or .35 when DVB-S modulation is used, and
either of the three when DVB-S2 is used. Use a small number to
reject or filter carriers close to the same frequency.
This is the Input signal spectrum inversion setting, which allows the
operator to track and select inverted and non-inverted digital
signals.
When set to Auto, received digital signals are tracked and inverted
for correct selection, as required. When set to Inv (inverted), the
received digital signal is always inverted. Conversely, when set to
NonInv (non-inverted), the received digital signal is never inverted.
Normally set to Auto, Inv and NonInv are typically used to
automatically reject or filter out unwanted signals.
This is the Network ID of the uplink signal the receiver is to receive
when using this preset. The receiver's Network ID must match the
Network ID associated with the transmitted signal.
1 to 65535. The default value is 1.
This setting determines if power is provided via the RF1 Input to an
external LNB connection.
Off, 13V, 18V, V-NIT or H-NIT. When LNB Power is set to V-NIT or
H- NIT, the signal polarization is automatically read from the NIT.
Note: Power will not be applied to the LNB when Power is set to
Off.
4-35