Moip Outputs (Base Model) - Cisco D9854 Installation And Operation Manual

MOIP Outputs (Base Model)

1. Press MENU to move to the Main Menu.
2. Press
3. Press
4. Press
5. Press
Rate Control. Use
results in the device setting the output rate to be the same as the input rate. Press
SELECT. Press
keypad to enter the desired bit rate. Press SELECT to save changes.
6. Press
output mode for your application. Press Select. Press
Descrambling Mode menu. Press SELECT. Use
mode. Press SELECT.
7. Press
change the selection to "No". Press SELECT.
8. Press
RTP. Press SELECT.
9. Press
SELECT. Press
number using the keypad. Press SELECT to save the change. Press
the source port. Press SELECT and enter the Port number using the keypad.
Press SELECT to save the change. The default is zero, which allows the system
to assign a port.
10. Press
Press
11. Press
12. Press MENU to exit the menu level and save the changes.
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
!
to move to the Setup menu. Press SELECT.
#
to move to the Outputs menu. Press SELECT.
!
to move to the TS Out menu. Press SELECT.
!
to move to the MOIP menu. Press SELECT. Press
"#
to select "USER". Selecting "Auto" for Rate Control
!
to move to the User Rate menu. Press SELECT and use the
#
to move to the Output Mode. Press SELECT. Use
# !
. Press to move to Insert Null Packet. Press SELECT. Use
#
two times. Press SELECT. Use
#
. Press SELECT. Enter the Destination Address using the keypad. Press
!
to move to the UDP Port. Press SELECT and enter the Port
# !
. Press two times to move to PCR@IP Start menu. Press SELECT.
#
to set value to "No". Press SELECT to save the value.
# !
two times. Press
Base Model
"#
"#
to change the selection to UDP or
to move to PCR Addition. Press
!
. Press SELECT for
"#
to choose the
!
to move to
to select the scrambling
"#
to
!
to move to
#
to select "No".
1-9