Cisco D9854 Installation And Operation Manual page 106

Setup Menu: Services,
OSD Messages
Description:
Parameters:
TV A/R
Description:
Parameters:
Convert
Description:
Parameters:
Stream
Description:
Act Conv
Description:
Refer to the following table for the conversions performed by the receiver based on
your selection, and the effect on the picture displayed by the receiver in each case
(without Auto AFD).
Stream TV A/R
4:3 4:3
4:3 4:3
4:3 4:3
4:3 4:3
4-44 Model D9854 Advanced Program Receiver Installation and Operation Guide
Continued
Sets whether alarms and warnings are to be displayed on the on-
screen display (e.g., TV monitor).
Enable or Disable.
This is the aspect ratio of your TV.
4:3 or 16:9 (wide aspect ratio). The default is 4:3. Set it to the
corresponding value.
This is the conversion that the receiver will perform on the
incoming signal for the picture to be displayed correctly (i.e., to
correspond to the aspect ratio of your TV) on your TV, based on
your selection.
Auto, None, Auto AFD (Auto setting using Active Format
Descriptor), 16:9 L/B (letter box), 4:3 P/B (pillar box), 14:9, 4:3 CCO
(Centre Cut Out), 16:9 SCALE. The default is set to Auto.
This indicates the aspect ratio of the incoming signal. This is read-
only.
This is the type of (aspect ratio) conversion the receiver will perform
based on what you have selected. This is read-only.
Conversion Act Conv
None None
Auto None
16:9 L/B None
4:3 CCO None
Description
Normal Picture
No conversion
Conversion is not possible.
Normal picture.
Conversion is not possible.
Normal picture.
Image
4021470 Rev D