Messages - Cisco D9854 Installation And Operation Manual

Messages

General
The status of the D9854 receiver and its immediate surroundings is reported to the
front panel in the form of messages and alarms. You can enable or disable messages
in the Alarm/Warning settings.
D9854 Receiver Message List
The following table shows an alphabetical list of the available messages and their
default alarm status. The Set Messages and Clear Messages are displayed in the
Warning History when the messages are set or cleared respectively.
Note: Only alarm conditions can be used to trigger rear panel relays to control
external alarm equipment. Warnings are not associated with relay operation.
Alarms
Alarm Message
Type
Signal Status Set
Clear
4021470 Rev D
Message
ASI Signal - No
Content
RF Signal - No
Content
Signal is lost
Tuning Parameters
Invalid
Signal is locked
Tuning Parameters
Valid
D9854 Advanced Program Receiver Installation and Operation Guide
Cause/Remedy
Cause: Loss of ASI/
RF lock. Loss of
Transport data.
Invalid frequency
parameters. External
to IRD.
Remedy: Check
tuning parameters
and ASI/RF cables.
Description Severity
ASI Link Minor
Locked, but no
TS content.
RF Tuner locked,
but no TS
content.
Loss of signal
One of the
tuning
parameters is
invalid
Signal OK
Tuning
parameters are
valid
6-3