Audio Device Sdi1 Or Sdi2 Output Settings Command - Cisco D9800 Reference Manual

Decode Configuration Commands

Audio Device SDI1 or SDI2 Output Settings Command

Table 181: Command Details
Command Detail
Command URL
Command Information
HTTP Methods
Access Type
Access Level
GET Syntax
POST Syntax
Setting parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
Note
Table 182: URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
URI Argument
Sdi1output
Sdi2output
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
220
Description
https://192.168.0.1/ws/v2/service_cfg/decode/audio (for SDI1 or SDI2
Output Settings)
Allows set or get of audio decode SDI1 or SDI2 output settings
parameter.
GET, POST
Read, Write
User, Admin
GET "https://192.168.0.1/ws/v2/service_cfg/decode/audio? sdi1output"
POST "https://192.168.0.1/ws/v2/service_cfg/decode/audio?
sdi1output=[sdi1_stringvalue]..."
All of the URI Arguments below apply to both GET and POST. For GET, the URI arguments do not
need any values. For POST at least one of the arguments must be specified along with the associated
value the user would like to set. In-depth CURL examples can be seen below following the table.
Description
SDI1 Output Mode
Type: String
Value: "PVO", "SD"
SDI2 Output Mode
Type: String
Value: "PVO", "SD"
API Definitions