Quick Setup Instructions For Rf Acquisition - Cisco D9854 Installation And Operation Manual

Quick Setup Instructions for RF Acquisition

1. Press MENU to display the Main menu.
2. Press
Input menu. Press SELECT.
3. To setup the ASI input port, go to step 4. To setup the RF1 input port, go to step
5.
4. Press SELECT twice. Press
SELECT. Press MENU three times to return to the start-up menu. Go to step 12.
5. Press SELECT. Press
port parameter to Act (Activate). Press SELECT.
6. Press
application. If no change is needed, go to Step 7. If required, you may modify
these settings. Use
SELECT. Use the numerical keypad to enter new frequencies. Press SELECT.
7. Press
"#
Use
!
to choose Rolloff. Press SELECT. Use
SELECT.
8. Press
the RF frequency. Press SELECT. Press
SELECT. Enter the symbol rate. Press SELECT. If DVB-S2 is used, proceed to
step 9. If DVB-S is used, press
AUTO. Press SELECT.
9. Press
SELECT. Enter the value. Press SELECT.
10. Press
RF1 port is capable of providing 13V or 18V. Press SELECT.
11. Press MENU three times. Press
& Exit will return you to the Main: Setup menu; Abandon & Exit will go back to
the last menu accessed with the original parameters; Cancel will go back to the
last menu accessed with changes saved.
12. The receiver will search for the signal and display "Acquisition Successful". It
will find the first available channel on the network. Press MENU twice to return
to the start-up menu.
1-4 Model D9854 Advanced Program Receiver Installation and Operation Guide
!
to get to the Setup menu. Press SELECT. Press
!
to go to RF1. Press SELECT twice. Use
#
to move to the LO1, LO2, Xover menu. Verify these parameters for your
!
to move to the parameter that you want to modify. Press
#
five times to move to the Modulation and Rolloff menu. Press SELECT.
to choose DVB-S or DVB-S2. Press SELECT. If DVB-S2 is used, press
"
to move to the Freq., Sym Rate, and FEC menu. Press SELECT. Enter
#
twice to move to the Net ID menu. Press
#
. Press SELECT. Use
#
to set the ASI port to Act (Activate). Press
"#
to choose the value. Press
!
to move to the Sym. Rate menu. Press
!
to go to FEC. Press SELECT. Use
"#
to change the LNB power, if needed. Only the
!
to move to Save & Exit. Press SELECT. Save
!
to move to the TS
#
to set the RF1
"#
!
to choose Net ID. Press
4021470 Rev D
to select