Cisco D9854 Installation And Operation Manual page 137

Setup Menu: Outputs: TS Out: DPM,
PMT
Description:
Parameters:
PID (Press Select to view this level)
InTyp
Description:
PID
Description:
Parameters:
Act
Description:
Parameters:
OutType
Description:
Parameters:
In
Description:
Parameters:
PID
Description:
Parameters:
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Continued
This is the DPM output PMT/service ID, which is the same as the
input PMT if it is present. the This value is only used if the PE
Action is set to MAP
0 to 65535.
This indicates the input program stream category/service type. This
value is read-only.
This indicates the input program PID. This value is read-only. It is
only used if the PID Action is set to Map.
1 to 8190.
This selects the DPM action for the PID associated with the PE.
Pass, Drop or Map.
This selects the output program stream category/service type. This
value is only used if the PID Action is set to MAP.
UNKN, CDT, LSDT, DATA, TTX, MPE, DPI, VBI, SUBT, AUD, VID,
PCR or INVL.
This selects the output stream instance.
1 to 64.
This selects the output program PID.
1 to 8192.
4-75