Setting Up Ethernet Ports - Cisco D9854 Installation And Operation Manual

Setting up Ethernet Ports

Setting up the Ethernet Ports
Proceed as follows to configure the Ethernet ports:
1. From the user interface of the D9854, click the System tab, and then Ethernet
icon from the sub-page.
2. The Ethernet Setup page allows you to set the parameters for communicating
with other equipment via the Ethernet Data and Management ports for
MPEGoIP and MPE applications and upgrading application software.
3. In PortName, enter the description or name for the Ethernet port. You can enter
up to 20 alphanumeric characters in length.
4. Set the IPv4 address for its participation in a Network environment. The
address is 12 digits in length (###.###.###.###).
5. Enter the IP v4 Mask for its participation in a Network environment (8 to 30).
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 5-71