Cisco D9854 Installation And Operation Manual page 265

Warning
Transport Error
CI Status
Video Format
Mismatch
4021470 Rev D
Message Message
Type
Set Continuity Count
Error
Buffer Overflow
Transport Error
Indicator
Transport Rate Error:
FPGA Overflow
Clear Continuity Count
Error Cleared
Buffer Overflow
Cleared
Transport Error
Indicator Cleared
Transport Rate Error:
FPGA Overflow
Cleared
Set Different CA Systems
in Top/Bottom Slots
Clear OK
Set Video format
mismatch
Clear Video format match
D9854 Advanced Program Receiver Installation and Operation Guide
Cause/Remedy
Cause: Possible uplink or
signal issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Cause: Uplink settings may
have changed since setting
up the unit.
Remedy: Increase the
output rate, drop
unreferenced content in
DPM Options, and/or drop
programs not needed for
downstream devices.
Contact your (uplink)
service provider to verify
the expected bit rate
settings.
Cause: Different CA
systems are used in the
slots.
Remedy: Replace the CA
cards to use the same CA
system.
Description
Transport packet
continuity count
jumped. Possible
packet loss.
The transport stream
is faster than the
maximum buffer or
the decode engines
are having difficulty
handling the data
sent to them.
Transport packets are
marked as "errored"
upstream of the
decoder.
The output rate is
higher than level set
by the user.
Trap expires after 30
seconds.
Different CA Systems
in Top/Bottom slots.
Video Format
Mismatch.
6-17